Sport a custom designed spare tire cover
graphic on the back of your motor home or vehicle. For just $69.95 + S&H,
I will get you a custom round graphic to apply to your spare tire cover.
These will be solid vinyl, to give you a
These round spare tire cover graphics are 24" diameter and
sized to be used on most tire covers.
I suggest these for on solid spare tire covers. Applying them to a soft
tire cover may not get as good a bond as needed, unless you have the tire
cover extremely clean and apply the graphic with the tire cover flat on
a hard surface.
Clean your tire cover with a water and alcohol mixture to remove any waxes and
grime. Make sure the surface is clean and dry.
Place the tire cover flat on a hard surface, and position and trim the tire
cover graphic to fit your needs.
When ready to start installing the graphic, I suggest taping the graphic to the
tire cover, and then folding back one side, peel the backing off the graphic
Cut the backing off, making sure you do not scratch the tire cover. Start
smoothing the graphic onto your tire cover, using the palm of your hand.
Be sure you do not get wrinkles in the graphic. If you get any wrinkles, peel
back the graphic and smooth them out as you reapply.
When you complete the first half, repeat the process for the other half. Once
fully installed, smooth the whole graphic, for maximum bond to the tire cover.
Allow about a week in the sun before using car washes that could cause the
graphic to come loose.
The solid vinyl graphic will possibly have air bubbles
under the vinyl material, which you will need to remove as you install.